Thursday, January 14, 2010

Panasonic Projector Bulbs Panasonic Projector Lamp?

Panasonic projector lamp? - panasonic projector bulbs

I bought a Panasonic PT ax100u projector lamp can expect to live approximately 800 hours about 700 began to run once and must then be activated and works well ... and later after 4 months and after loading the damn thing 5 times before it stays in the curious, whether it is a topic of discussion or anything. I just died or paler than incandescent light bulbs for 2 weeks, then she died ... Ideas?

2 comments:

agb90spr... said...

I do not know that the projector off, and although they may the light bulb may be a different matter. Not help much, so far ... Huh?

Note three things ... first 800 hours is very low. 2000-3000 Clock is typical (even though the bulbs could explode at any time ... especially when the projector lamp is turned off before the lack of cooling, power outages subjected to too hot, too long, etc..)

Second, the bulbs is usually little slow, but not break in the action. Recognizing what I've read that some projectors use a lamp timer to activate a visual alarm at a certain point, then closed the projector within the limits specified by the manufacturer. Do not think this is common, but it has happened. In other words, would be a bad system, which is still allowed, after several avatars start closed again. But you never know ...

Thirdly, some sort of problem with the cooling (For example, a semi)-closed or clogged filter cooling. That is, it is usually a go / no go "on the basis of the activation of protection circuits, because heat rises, rather than intermittentWhat t. But maybe ...

The real test would be to try to put a replacement lamp (which I now, right?) And see if it solves the problem. Otherwise ... It is a different matter. If yes, was the lamp.

Unless you change the lamp --- In this case, you probably have an answer to the question of whether the lamp or something else - you should probably bought with the support of Panasonic or the retailer, check and see what, if they say you describe the problem.

Good luck.

agb90spr... said...

I do not know that the projector off, and although they may the light bulb may be a different matter. Not help much, so far ... Huh?

Note three things ... first 800 hours is very low. 2000-3000 Clock is typical (even though the bulbs could explode at any time ... especially when the projector lamp is turned off before the lack of cooling, power outages subjected to too hot, too long, etc..)

Second, the bulbs is usually little slow, but not break in the action. Recognizing what I've read that some projectors use a lamp timer to activate a visual alarm at a certain point, then closed the projector within the limits specified by the manufacturer. Do not think this is common, but it has happened. In other words, would be a bad system, which is still allowed, after several avatars start closed again. But you never know ...

Thirdly, some sort of problem with the cooling (For example, a semi)-closed or clogged filter cooling. That is, it is usually a go / no go "on the basis of the activation of protection circuits, because heat rises, rather than intermittentWhat t. But maybe ...

The real test would be to try to put a replacement lamp (which I now, right?) And see if it solves the problem. Otherwise ... It is a different matter. If yes, was the lamp.

Unless you change the lamp --- In this case, you probably have an answer to the question of whether the lamp or something else - you should probably bought with the support of Panasonic or the retailer, check and see what, if they say you describe the problem.

Good luck.

Post a Comment